June 9, 2022
Description
I'm not sure what model this block is since I couldn't find it anywhere on the website. The block(with the stock bracket removed) is somewhere around 50x50mm. Should fit snugly. Print with relatively high infill and 4 shells minimum.
Take off the stock bracket with the 4 screws on top. My motherboard used 6/32 screws to attach the heatsink. You'll need longer ones I decided that 25mm was the right length but they only come in inch lengths so 1 in is fine. Make sure to tighten it in the cross pattern(corner to corner) to make it go.
Printer Brand:
FlashForge
Printer:
Creator Pro
Doesn't Matter
Supports:
No
Notes:
Print in a higher temp filament. This part will have to withstand temperatures of up to 100C in the worst case without warping.
License:
Creative Commons — Attribution
9
Beefdip
