April 30, 2024
Description
There are various version of this angled (15°) shotgun shell holder / side saddle available.
On the uploaded picture (Maverick 88) I used the 12G_5pcs_25mm_angled_velcro version. As Filament I used Prusament PETG with Carbon Fibers (Black).
Check the Key below to select the correct model for your shotgun:
| 12G_4pcs_25mm_angled_velcro | 12G = Caliber (12 Gauge) 4pcs = Capacity 25mm = Width angled = Shell direction/position velcro = Mounting |
Note: The angle is 15°.
Use PETG
Perimeters: 3
Solid layers Top & Bottom 5
Infill: >35%
No Supports
Note: Place the shell holder on the heat bed in the same direction as you would mount it.
Velcro Strip
(I used tesa On&Off extra strong)
Note: Use the “Loop”-side (German: Flauschband) on your gun and the “hook”-side (German: Haftband) on the holder. Btw: loop is the soft side, hook is the harder side of the velcro strip.
The shell fit is quite tight and needs to wear in a little. Let me know about yours!
Happy printing and let me know if you need further information or instructions.
License:
Creative Commons — Attribution — Noncommercial
11
Theroux
