May 5, 2024
Description
Warning
None.
Definition
None.
Printing
Is required the same printer size than 3D SETS has defined.
Infill 15% and layer 0.15mm is fine.
Build
Use the holes for the top/middle screws according to the weight distribution of your Sakura.
Feedback
It is welcome.
Remark
This modeling was carried out to meet a need of a 3D SETS Sakura 240 owner who validated this design. Big thanks to him.
Not owning the 3D SETS license for the Sakura 240, if upgrades were to be required, it will be difficult for me to do them without testing by a third party.
Version
v1/v20240505 1st upload.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
9
mbe075
