November 16, 2021
Description
Designed a container for my partner who loves pineapples. The body of the pineapple is designed from scratch, the leaves are copied from The Pineapple right here on Thingiverse.
Scaling to 84% makes a container that holds roughly 550ml, perfect for holding tea. Say green lemon pineapple rooibos. I used tree supports in Cura, only to buildplate, should be a minimal ring of supports on around the bottom. The inside is designed to be printed without supports.
Might need slight sanding for the lid to fit flush, depending on tolerances of your printer.
Remember to use food-safe materials if you're putting food (like tea/coffee) in this.
Printer Brand:
Prusa
Printer:
Mk2.5s
Yes
Supports:
Yes
0.2mm
Infill:
20%
Notes:
I used tree supports, only to baseplate. The inside is designed to not need supports.
License:
Creative Commons — Attribution — Share Alike
DocWilco
