MK4(S) Raspberry Pi case connector

This is a connector to connect my MK4 Raspberry Pi case to the MK4's electronics box.

Additional required materials (slight variations in the length are ok):
- 2 M3 screws (10 mm long)
- 3 M3 screws (5 mm long)
- 5 M3 nuts

Note that the installation is a bit tricky, the order of operations is:
- Insert the 5 M3 nuts into the respective holes.
- Remove the MK4's electronic box cover.
- Screw in the connector from the inside.
- Slide the electronics box cover back ( this step my also require you to remove the 3D printed part on the bottom of the box that says “PRUSA” on it) (for this step you have to bend the connector and the cover a bit)
- Now screw in the bottom of the Raspberry Pi case.