May 13, 2024
Description
I needed something as a stand in until I upgrade to a V mount battery setup, so I made a cage that would hang from a set of 15mm rails.
When I printed it, I printed it laying down with the holes facing up. This caused a problem getting the supports out of the bottom holes, and I had to bore them out a little. I would look at printing it laying down, but with the holes on the side.
The rails will block one of the USB C ports, but I'm only using one, so I did not go back to re-work this. Just a heads up.
License:
Creative Commons — Attribution — Share Alike
jakeg1111
