Sovol SV06 Spool Side Mount

This is a remix that doesnt require t-slot nuts, should be printed like I uploaded it for better strength.

----------------------


Original Description
 

What is it and why you may need it.

It is a Side Spoolholder for the Sovol SV06. I created it because I didn't have room above the printer to mount the Spoolholder. It is at a slight angle so the Filament would feed smoothly in the Extruder without any hiccup.

Print Settings:

• Orientation: I recommend printing it in the orientation that I uploaded it.
• Infill: 25% and above
• Support: No Support needed because the screw holes for mounting it to the printer have a sacrificial layer which just need to be either drilled out or with a screw and a bit of force pushed through.

How to Assemble:

Just Screw the Filament Holder in to the 3D Print with the to Original M5*10mm Screws. Like seen in the Picture below.

Then you Add in The other Two holes 2 M3*12mm screws and 2 T-Slot Nuts. Then Just Screw it to the aluminum extrusion.