December 10, 2025
Description
Remix of Wiseone's model to hold gardening gloves and to hang them on shed's wall. The original model was made to clip to a belt so I remixed it.
Printed on PETG at 0.20mm 25% infill (15% should be fine) and supports. Took around 45 minutes to print.
v2: (15/05/2024) Updated the model with a fillet and variants to have the hanging hole in opposite directions - one parallel with the grip section, one perpendicular/square/at 90 degrees against it.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
6
pjvenda
