TRIMUI Smart Pro Hardshell Magnetic Case

Magnetic case for the TRIMUI Smart Pro

You can print this without any overhangs or special settings! The real work is in the assembly. Use a piece of 1.75 mm filament as the hinge. Cut the filament at the end of the hinge and superglue or use a soldering iron to seal the ends. I used 6.5 x 1.58 magnets and super glued them to the obvious holes. 

I recommend to print in a filament that can be glued easily such as PLA, PETG was a bit too hard to get the magnets to stick and I had to use waayyyyy too much glue. 

Use a self adhesive felt lining or foam on the inside to prevent your device from sliding around and some on the square indent on the top side to protect your screen.

If you want to buy it printed from me feel free to buy it here!
https://dildesigns3d.etsy.com