Using a 0.2 mm nozzle would be a great advantage, but the profile is optimized so that it can also be printed with a 0.4 mm nozzle as you can see in the pictures
Changing settings can lead to printing errors, so be careful when changing anything
When choosing the color, the effect is more visible when the background is lighter than the blades
As the blades are very thin, I had the problem that they were not printable in the middle of the plate. However, this was not a problem in the front area.
So if you have the same problem, try placing the model on a different part of the plate.
Assembly
Insert the parts into each other and check whether they can be turned without force
Enlarge the hole in the lower part if necessary
Use a hair dryer to remove stringing
Stick a few pieces of double-sided adhesive tape onto the housing
Now stick the lower part onto the adhesive strips
It is designed so that normal adhesive strips can be used, which are slightly thicker
Now place the upper part VERY CAREFULLY on the axle of the extruder
Press carefully in the middle until the part is firmly attached to the axle
If the upper part does not rotate while extruding, it is not properly attached
Mici
