Even base for PTFE-Hub

Have you already printed the hub and then noticed, that you don't need the angle because it would be better, when it's perpendicular to where you want to mount it?

Yes, I have. So I didn't want to print the whole part again and decided to design an additional part to mount to the bottom.

There are two versions:

Standard: With hexagonal cutout for M4-Nut. I used this one with a M4x8mm screw. Also I used double-sided tape for mounting it because I don't want everything screwed on top of the lack-enclosure for future improvements.

NoNut: Only with 5mm hole for M4 Screw, so you can screw it with the other part directly where you want it.

My Print Settings/Instructions

Orientation: Upsided down, so the upper face is more flat after the print. Also you don't have to use supports for the hexagonal cutouts.

Layer Height: 0.2mm (Mk4 Speed with InputShaper)

Infill: 15% (Maybe less is also possible

Support: None, if the orientation is correct.