June 17, 2024
Description
Printing instructions:
0.2 layer h
4 walls
top surface pattern : hilbert curve
normal auto supports
supports on build plate only : yes
10% cubic infill
Seam position : back
You can stop the print to change the filament for the logo. Look that there were no seams inside the tunnels. You can also paint red for supports from under the model where the hole is to save some time.
This version is a little bit chunkier, but prints faster (in less than 90min) and looks better. I designed this in fusion360. Added better quality and bigger creality logo. Tubes should fit perfectly.
License:
Creative Commons — Attribution — Share Alike
7
Big B
