Large Dwemer Plate Steel

One sided Large Dwemer Plate Steel, created based on in-game screenshots.

I do have a mostly completed 2 sided version but decided against it, to reduce both supports when printing and post processing time. If someone is interested in this version, let me know and I will finish it off and upload it.

The make in the photo was;

• Printed on an Ender 5 plus
• 0.2mm layer height
• 3 perimeters
• 5% infill
• 30.5hr print

For post processing, see below steps if you want to some tips on replicating the same look in the photos.

• 80 grit sanding for the first round
• Initial filler used was Rosco Foamcoat
  • After mixing the Foamcoat within the tub, I separated a small amount and every so often dipped my brush in was water, as I brushed the Foamcoat on
• 320 grut sanding before filler primer
• 1 coat of MTN Pro Grey filler primer
• 400 grit sanding before paint
• 1 coat of Rust-Oleum 2x Ultra Cover - Espresso Satin
  • Shout out to @SilverrendProps for the advise on how to achieve the Dwemer look in the photo
• Sponge on some Rub'n'buff Antique Gold to the desired effect
• Spray a coat of sealant