The make in the photo was;
- Printed on an Ender 5 plus
- 0.2mm layer height
- 2 perimeters
- 5% infill
- 11.5hrs print time
For post processing, see below steps if you want to some tips on replicating the same look in the photos.
- 80 grit sanding for the first round
- Initial filler used was Rosco Foamcoat
- After mixing the Foamcoat within the tub, I separated a small amount and every so often dipped my brush in was water, as I brushed the Foamcoat on
- Let this dry
- 320 grut sanding before filler primer
- 1 coat of MTN Pro Grey filler primer
- 400 grit sanding before paint
- 1 coat of Rust-Oleum 2x Ultra Cover - Espresso Satin
- Shout out to @SilverrendProps for the advise on how to achieve the Dwemer look in the photo
- Sponge on some Rub'n'buff Antique Gold to the desired effect
- Glue the parts together
- Its easier to colour the S1/S2 & S2/S3 Connectors, as well as the top & bottoms for each section before assembly
- make sure to use the spacers
- Spray a coat of sealant
Builds for geeks
