IR Turret Nerf Dart - Crunch Labs Hack Pack 001
Overview
This is 3D-printed replacement ammunition. No rubber band is required. The spring is 3D-printed.
3D Printing Info
- Print Time: Approximately 30 min on Prusa MK4
- Material: PLA/PETG
- Supports: Yes
- Infill: 20%
- Layer Height: 0.2 mm
- Perimeters: Default
Notes
- I add a slight bend to the circle at the end of the spring (notches on the shooting end). This makes it easier to latch on.
- I adjusted the design to minimize supports but this means the fins are shorter than the original.
- The circle/latch is at the edge of the nerf bullet vs. the center. If it was placed at the center, it wouldn't fire straight.
- Unsure how the spring will hold up. I'd recommend not keeping loaded on the turret when not in use to reduce wear.
Updates
- 5/27/2024 added stronger spring to go ~3x farther (v2)
- 5/27/2024 hollowed center of cylinder to improve aerodynamics
License:
Creative Commons — Attribution — Noncommercial
ahaque
