Designed for the AxxSolder Controller.
Hard- and software are available on GitHub. The controller can be bought on Tindie.
Power Supply
DC input source 9-24V or USB-PD power supply. Depending on the handle the power requirements may vary. When used on USB-PD the power is limited depending on the source capabilities.
When using a USB-PD souce it should be able to provide at least 12V and 25W.
I modified an old 150W Dell laptop power supply with an XT60 conntector and this housing.
The stand can be attached to the base via magnets. I modified the base and connected the handle sense pin to one of the magnets. When base and stnad are connected the controller goes to standby temp as soon as the handpiece is in the stand. When using stand and base independently you can control standby by pushing the rotary encoder.
Required Hardware
- AxxSolder controller- Tindie
- XT60E-M - Amazon
- Power Switch 19.7mm x 13.1mm - Amazon
- Connector RPC1-12P-6S - Mouser
- Magnets 20x7mm - Amazon
- Stand - AliExpress
- Other hardware
- Nut M3 x4
- Nut M2.5 x4
- Nut M2 x4
- Socket Head Screw M2.5x12mm x4
- Hex Drive Flat Screw M2.5x8mm x2
- Hex Drive Flat Screw M2x16mm x4
- Hex Drive Flat Screw M3x8mm x2
- Hex Drive Flat Screw M3x12mm x2
- Self Tapping Screw 1.7mm (for bottom cover)
Compatible Handles
- JBC C115 - max. 20W
- JBC C210 - max. 60W
- JBC C245 - max. 120W
- Aixun T115-A AX
- JBC C115 compatible
- order 6 hole handle jack variant
- modifying the connector is necessary
- AliExpress
- Aixun T210-A AX
- JBC C210 compatible
- order 6 hole handle jack variant
- AliExpress
- Aixun T245-A AX
- JBC C245 compatible
- order 6 hole handle jack variant
- AliExpress
Cartridges/Tips
- of course the JBC cartridges deliver the best performance and are recommended
- KSGER C115/C210/C245 - AliExpress
- Phonefix C115 - AliExpress
- Phonefix C245 - AliExpress
Available Files
- bottom_cover
- magnet_holder
- Gets mounted to the base. Disaseemble the base and drill two 3mm holes to screw the magnets with the magnet holder to the base. one of the screws is sued to connect the sense handle
- case
Printing Instrucions
- Printed on BambuLab X1C
- Bambulab PLA filament
- resolution 0.2mm
- BambuLab “optimal” profile with default settings
NightHawk
