Articulating Speaker Wall Mount

Created for my Vizio soundbar surround rear speakers, with index holes for the dots that are on that speaker cube/mount. However, this could be used for other speakers attaching an appropriate interface to this.

Printing:

I printed in the orientation shown in the images with build plate supports, but it should print fine without supports if you print the mid hinge on it's top/bottom orientation.

I used PLA w/ 15% infill.

Optionally, I did fuzzy skin @ 0.1 thick / 0.15 point distance, on all but the knob & cap, to give it a less 3D printed look.

Hardware needed:

• 2x ¼-20 bolts @ 2" length
• 2x ¼-20 nuts
• 2x washers
• 2x pan-head screws for mounting to wall (drywall/concrete anchors may be needed)
• 1x M4x10MM pan head bolt to attach the speaker mount cube
  • I used a M4 tap to tap the hole. A heat insert or screw from behind the “interface” part may be needed if you speakers are larger/heavier.

Assembly:

1. Ream & tap thread onto “Speaker interface” part
2. Attach speaker mount/cube onto Interface w/ M4 bolt
3. Insert bolt into knurled knob, open side toward bolt head
4. Place cap on knob
5. Add washer to bolt
6. Insert nuts into hinge parts
7. Assemble remainder as seen in photos

If you make or remix, I'd love to see it, so please tag/upload. Enjoy