Apple AirTag clone bike bottle mounts - 2 different styles

Hi, I have created some stealth mounts for a couple of the clone AirTags that are out there. Clones are obviously cheaper than the real thing and they are a little bigger, so they won't fit into the holders that are out there.

These fit the shapes that are in the photos. If you want some designed for any different clones shoot me a message and I'll see what I can do.

The model is suited for M5 screws at 65mm centres to screw it into place, this seems to be the industry standard.

The model is made in two parts, with the top designed to go over the bottom and try keep the water out. If you want you can smear a layer of Vaseline around the base of the bottom so when you put the top on it creates some sort of seal to try keep the water out a little better, usage may vary :).

There is 0.5mm clearance between the base and the top, even the worst calibrated printers should be able to knock these out fine :)

Comments, both good and bad always appreciated

G