OpenDTU Socket Outlet Enclosure

This is a special case for the OpenDTU breakout board by blinkyparts.com which could be attached directly to a socket outlet (SCHUKO)

Printing instructions

Backside 

• Material: PLA, PETG, …
• Perimeter: 2
• Infill: 15%
• Supports: yes, I used organic support.

Front cover 

Should be printed with front side on the bed.

• Material: PLA, PETG, …
• Perimeter: 2
• Infill: 15%
• Supports: no

BoM

Assembly

1. First place the OLED-Display within the cover. See pictures.
2. Connect the display and the circuit board with the cables
3. Attach USB-C cable to circuit board
4. Clip the circuit board together with antenna board attached within the case. Pay attention that the LEDs are placed correct in the wholes. maybe you have to adjust them.
5. Pass external antenna through the whole and screw it on the base.
6. Push USB power supply in back element. Should be a little bit tight.
7. Attach USB-A of cable to the power supply.
8. Do a short test by plug in power socket and check if everything works and is connected correct.
9. At last step push backside into back of front part. It should snap in.