3DO nozzle cam V2 setup for Ratrig toolhead VC4 VC3.1 and EVA 3

update..

added the Chube mount.
Disclaimer!! use at own risk (the camera is pretty close to the hotend) 

update… 
corrected the focus distance for VC3.1 RR toolhead and EVA 3 (November 24.)
added the body for VC3.1 RR toolhead and EVA 3 short standard (November 24.)
added the body for V-Minion 1.1 RR toolhead (November 24.)

added the body for VC3.1 RR toolhead and EVA 3 (October 4.)

!!!!!!only works for V2 nozzle camera from 3DO !!!!!!!!

this mount is made for this camera from 3DO

3DO Nozzle Camera Kit V2 - Sony 4K for 3D Printers

remember to chose 10cm FPC

BOM
4pcs short M3 heatinserts
2pcs M3x10/12 (both lengths work) for the clamp
2pcs M3x8/10 (both lengths work) for the cover

Assembly
insert heat inserts
put in FPC cable
slide camera into position
mount the clamp ( be careful not to damage the camera/lights)
gently fold the excess FPC under the PCB plate
and mount the cover on top of PCB

Attention!!
put FPC cable in one notch at a time without damaging it.
if you want to remove FPC cable, then slide in a zip-tie underneath and gentle pop it out

VC4 is tested
EVA 3 is tested ( may need longer screws for mounting )

VC3.1 is untested