TBS Source One V.02 - Water Bottle Holder

Created this for those times when I want to fly over water. Normally I pull out the Electrical tape and wrap the hell out of it, which is painful since every time I need to change the battery I have to re-tape it again. With this I just use a few zip ties, and call it a day.

I would only use this if you print this in TPU, if you don't want to lose your drone!

Also cinch down the zip ties good, so the water bottle doesn't get lose on a water impact.

Also I'd recommend spraying a little orange paint inside the bottle before you fly, which will make it a lot easier to spot if you do crash it.

Print instructions

Category: R/C Vehicles Print Settings

Printer Brand: Prusa

Printer: i3 MK3 MMU 2

Rafts: No

Supports: No

Resolution: .2

Infill: 25%

Filament: Sainsmart TPU black
Notes:

Only use TPU!!!