June 27, 2024
Description
Haven't had a chance to field test this one fully.
The retention on the bk9 could probably be improved, although i haven't had an issue with it yet.
I wanted to make it a slip-on but 95A isn't ridge enough to handle it. So it is full loop only
Designed to fit a normal size Bic lighter, there is a hole in the bottom of that slot to accommodate my 0.5" ferro rod if i take that instead.
Multitool/Flashlight clip slot is 9.5x8mm
Belt slot is 6.5cm tall and 3mm deep, was thickened from previous version.
Printed on it's flat side, without any supports and a brim on a Neptune 3 Max. 16Hr print
Layer Height is 0.28mm
Walls/top/bottom:2mm thick
Infil: 15%
Bed/Nozzle: 60c/230c
License:
Creative Commons — Attribution — Noncommercial
11
Loyalist
