Golf Ball grabber / retriever and cart clip

Printed on a Prusa Mini (with Bondtech extruder) using Flexfill 98 (TPU ok too)

Print with supports.   Use a heat gun to pull the arms of the grabber in a bit so that it holds the ball firmly.

Grabber is installed on a steel shaft that I took from an old junk club.  Cut the head off and glued a drywall anchor into the end of the shaft with Goop adhesive then screwed the grabber down once the glue had set.

The cart clip is made to grip a standard steel shaft but will work with composites.

Clip fits the frame that holds the windshield/roof on standard golf carts.   Been used on Yamaha and E-Z go carts.

Big fan of the Beerware license.