Sturdy/Stackable Can Dispenser - Beer Dispenser for 500ml Cans

This beer/can dispenser for 500ml cans was made for festivals and outdoor events. Therefore it should not be to unstable and could be carried without falling apart. Therefore it is printed in several parts to ensure stability by the layer orientation.

Each side part weighs about 360-380 grams individually, so it is not economical in filament, but that is the compromise if it has to be sturdy.

To attach the parts to each other 6 connectors are needed. Glue them in place.

Printbed: at least 19cm x 24.2cm

If your bed is a little bit smaller I can try to adapt the model by shortening the lip. You should not scale the model as otherwise the cans will no longer fit in cleanly.

A small brim can help, the tab at the front/output lifted from my printbed by 1mm while printing but the print was successful.

Print:

• wall: infill 25%, min. 3 walls
• connector: infill 30%, min 5 walls