MGN9 Voron Toolhead Display Stand

Show off your favorite toolheads! Put them on your desk as decoration with this is simple stand with MGN9H and MGN9C mounting pattern.

Hardware:

• 4x heat-inserts - “voron spec” 3ID*5OD*4H

Note: 

Make sure outer edges are flat after adding heat inserts, use exacto knife if necessary, as heat-inserts could push plastic out a little bit.

Compatible toolheads:

• DragonBurner with MGN9H mount
• Yavoth same as above
• MiniSB
• WTH Burner with micron mount

almost any toolhead with MGN9H or MGN9C mount pattern should work.