Digital Caliper Holder

Snug caliper holder for round hole peg board. Board is 63.mm diameter holes on a 25.3mm hole-centre to hole-centre square grid. Panel is about 1mm thick.

It fits the three sets of calipers by different manufacturers that I have so it could well fit yours.

The holder hooks on and there's a hole on the back for a 6x3mm magnet. That magnet hole is a little tight and I'm working on figuring out how to make this better first time. But if you press the magnet in with a clamp it'll be fine.

I printed with supports with the model lying face up on the plate. I did that for the surface finish. Not tried any other orientations.

The model file does not include the initials of my workshop like the one in the photos.