Folkart / Apple Barrel 59ml or 2oz Painting Shelf Rack

Built to hold 59ml or 2oz hobby acrylics, such as FolkArt or Apple Barrel.

Will hold 25 bottles (59ml sizes).

Built to be sturdy but not costly, uses less than 500g of filament @ 10% walls w/0.4 nozzle. Two will fit on a 256 x 256 plate, however I suggest printing only one at a time.

If you need it shorter, slice horizontally. 

If you need it thinner, slice vertically.

Print on it's side to avoid the need for using supports. Only walls/infill will need to be printed. The .3mf is the correct orrientation.

Print Recommendations:

• Turn Brim ON (Auto works fine)
• Two Walls is plenty (0.8mm wide perimeter)
• Cubic or Gyroid infill (+/-10%)
• If using a Bed Slinger, limit speeds to no more than ~40mm/s. This is to avoid ringing as the print gets taller.
• Supports are Not Needed
• If using a (0.4 nozzle) = (0.3 Layer Height)
• If using a (0.6 nozzle) = (0.3 to 0.4 Layer Height)
• I suggest a 0.4 nozzle, as a 0.6 nozzle will use an unnecessary amount of filament on the walls. 

Please share if you get some use out of it.