December 17, 2021
Description
Lithograph frame in 2 pieces. The Frame will fit a 100x150x3mm (tall) lithophane. Depending on how accurate your printer is, it could be a bit tight. The Vertical pillars can be a bit delicate but have some bend to them if you need to wiggle a bit (not much...i've broken 2 prototypes but they were low infill.)
The top has some nobs to help align, but the whole thing is held together by the friction of the lithophanes in the frame itself. I've tested and one Lithophane will pull the frame together. You could also glue it down if you don't intend to change the pictures.
The bottom is completely open for you to provide whatever light source you prefer.
Printer Brand:
Prusa
Printer:
i3 MK3
Doesn't Matter
Supports:
No
0.15
Infill:
10%+
Notes:
Infill is probably best from 10% above. I wouldn't go much lower, but that's up to you.
License:
Creative Commons — Attribution
Devolve
