Sky-Watcher - Star Adventurer GTi - Control Knob Tool

A simple device that slips over the existing knobs for Azimuth (also fits the RA clutch knob, sorta) and gives a better feel and more control. Intended as a tool shared between the knobs, but could be installed permanently if you want (I don't recommend, but you do you). There's a bit of variance in the oem knobs so it may not fit well for you. Provided 3 slightly different diameters. 

Print Settings:

• 30% infill (could go lower, shaft is limitation and could probably survive at 15%)
• Cubic Infill, or other off-axis infill like Gyroid. Hex would probably be fine, too.
• No supports needed
• PETG Recommended for these versions, PLA might need different sizing for shrinkage/lack of.
• Knob part should be on build plate, opening up top.