Gmade R1 Portal 7 & 13 Degrees C-Hubs

This is a printable version of the alum. 7-degree C-Hub that Gmade sells as an upgrade
I have made a 13 degrees version too now, since 7 is not alot..

V2 Files are now corrected and should be fine to print.
Tolerances around the outer edge are corrected (Was a problem in previous version).
If you print it in Nylon, PETG, ABS, it should be plenty strong.

Your choice of 7 or 13 degrees :

• Complete Left and Right
• Split Top/Bottom Left and Right (No supports)
• • (Glue the parts together after the print)

• Or the newer and better WrHubs !
  UPDATE 2019 : I found the "Wrapters" which allow the use Axial AR60 cHubs/knuckles/universals for more steering throw. After 4 of them broke in not even a day (weak where you screw the cHubs into the adapter) i decided to remove that weak part entirely, effectively making a "WrHub". Cut the shafts to the same length, use the same tube for shimming as in the Wrapters instructions. 1 Additional 5x8x2.5 bearing needed per side (2 total) (same as those already in the portal box).

Print instructions

Category: R/C Vehicles