Associated Spur 32P 64T (GT2 Slipper)

This is what a Team Associated GT2 32P 64T spur gear would look like if it existed.
I ran a 56T (ASC7957) but needed a bigger one so i made one using Fusion 360.

This is HALF of it, print it twice and then use the 3 holes to screw some M3 in for alignment and glue both halves together using thin CA glue or something similar. Then remove the screws.

• Tolerances should be pretty close but it's best to drill the center hole cleanly using a 5mm drill bit before use.
• DON'T use a brim, you will never be able to remove it cleanly from the teeth.
• If your slicer supports it, use a small negative "Initial Layer Horizontal Expansion" to compensate the "elephants foot" effect of the first layer getting squished. I use (-0.16mm).
  UPDATE : I've ran this spur for 6 hours total now, no sign of failure anywhere ! Looks like eSun PLA+ is great for gears !

Print instructions

Category: R/C Vehicles