Undercarriage Fan Shroud for Lawsys New Carriage v2 - Solidoodle

Made an underside fan duct that fits Lawsy's NEW replacement carriages - centre front v2. i have an e3d v6 on my solidoodle, i dont know if it fits with another hot end.

It bothered me that the only fan duct out there was Lawsy's fan duct, which is made for a 30x30x5 mm fan, which is impossible to find. So i made one that can be adjusted to 30x30x7 or 30x30x10. (adjust to desired height using washers - see pictures).

i could not get it to print, so i made a stripped down version first, printed that, used that with a 30x30x10 fan to print the actual fan shroud. For your convenience i included the temporary fan shroud as well.

It can be printed without support standing on the face were the fan is mounted on it (picture 3). i printed this in PLA and it works just fine for 50+ print hours and counting. Use m3 bolts to secure the fan to it, the holes for this are a tight fit, no need for a nut.

if you didn't insert a nut into Lawsy's NEW replacement carriage v2, you will have to take it apart and insert them, this will not hold without those nuts (m3).

---description is a work in progress---

Print Settings

Printer Brand:

Solidoodle

Printer:

Rafts:

No

Supports:

Resolution:

0.2

Infill:

Notes:

This will not print if you don't already have a part cooling fan.. in that case, print the temporary fan holder, mount it under the carriage and use that with a fan to print the actual fan shroud (v3.1).

For the best result, print it again now with the actual fan shroud.

Category: 3D Printer Parts