When you're at the beach, drive this spike drink holder into the sand and keep your drink right where you want it, cool, and covered to keep out bugs and sand.
Features
- Vintage tankard styling with an embossed lion
- Can holder style or mug style
- Removable sand spike to resist tipping
- A flip top cover to keep bugs away from your drink
- Designed for North American and European beverage cans
Two lid types are provided. The North American lid will sit level to cover a North American 12 oz beverage can. The European lid will sit level to cover a European 330ml beverage can.
Slicer Settings (Cura)
Mug:
- Orientation - sitting on the bottom of the mug
- Layer height - 0.28
- Wall line count - 2
- Top layers - 4
- Bottom layers - 4 (increase for a heavier base)
- Infill density - 15%
- Infill pattern - lines
- Support - Required
- Support Placement - Everywhere
Lid:
- Orientation - open part away from bed; lid is upside down
- Layer height - 0.28
- Wall line count - 2
- Top layers - 4
- Bottom layers - 4
- Infill density - 25% (more if you prefer a heavier lid)
- Infill pattern - lines
- Support - Required
- Support Placement - Everywhere
Sand Spike:
- Orientation - pointing away from bed plate
- Layer height - 0.28
- Wall line count - 2
- Top layers - 4
- Bottom layers - 4
- Infill density - 50%
- Infill pattern - cubic
- Support - Required
- Support Placement - Touching build plate
Pivot Pin:
- Orientation - Laying on its side so the layer lines cross the pivot point
- Layer height - 0.20
- Wall line count - 99
- Build plate adhesion - Brim but you might not need it
Assembly:
- You may need to whittle or sand down the pivot pin slightly if it fits tight or use a small file to make sure that the pivot pin openings are actually round. Do not force the pin into the lid opening or a pivot pin opening may crack.
- Insert lid into top of mug with opening towards bottom of the mug
- Insert pivot pin through the mug lid anchor and lid.
- If the pivot pin fits snuggly then you are finished otherwise follow the next step.
- There is a small hole in the lid pivot area under the thumb tab. After the pivot pin is in place, either use a dab of superglue to hold the pivot pin in place, or if you'd like the option of removing the lid later, use a tiny sheet metal screw (M2.2) to secure the pivot pin.
- Screw the sandspike into the bottom of the drink holder.
Jesster
