Monitor Riser with Integrated Hub

If you own a specific model of Orico brand USB hub (see photos), and have a monitor stand that clamps to your desk and has roughly 4.5CM of extra clamping room, then this block of plastic might be for you! I designed it to raise my monitors up a tiny bit since I always felt they were slightly too low. The clamping USB hub slots into the printed piece lending it some extra strength. You may have to peel off the rubber bits on the hub in order for it to fit. 

The specific hub is called the “ORICO USB 3.0 HUB, Monitor-Edge and Desk-Edge USB 3.0 4-Port Clip-Type Hub, Extra Power Supply, Space-Saving, Compact USB 3.0 Clamp Hub, Ultra-Portable Travel Hub for Laptop”

I recommend printing with the flat face towards the bed. I printed mine with 20% cubic infill, 5 walls/top/bottom layers, in PETG, but I have no doubt that PLA would work well too. Mine holds the weight of two rather heavy 28 inch monitors with no signs of any deformation at all.