Prusa XL PSU cover with USB

This is a modified PSU cover for the Prusa XL that includes a USB-A connector providing 3.1A of power. To be used on the left or right (or both) but not the center PSU.

The hardware comes from the MOTOPOWER MP0609/A waterproof motorcycle USB charger kit, which you can find here:
https://www.amazon.com/gp/product/B01DYE54LI
https://www.amazon.com/gp/product/B01M7R8C2O (without fuse)

To install, remove the rubber coating from the USB unit while keeping the wiring intact. Place the end of the USB connector against the PSU cover. Slide it sideways until it aligns with the window, then push it in until it sits flush at the rear. You may choose to keep the fuse holder as is (cut the rubber cover). Use M2 x 10mm screws to secure everything into the modified PSU cover.

Please note, I will not be providing instructions on how to electrically connect this to your Prusa XL power supply. At this stage, you should have the necessary knowledge.

Disclaimer: I am not responsible for any misuse or potential warranty voiding caused by this modification.