FPV Rover 2.0 Sturdy Top

These are a couple of variations on components for the FPV Rover 2.0 by Markus_p https://www.thingiverse.com/thing:2952852, using his work as the foundation.

FPV Rover 2.0 - Sturdy Top

It is a re-mix of the top panel of the FPV Rover by Markus_p. It used first version top_without_vents.stl (https://www.thingiverse.com/thing:1240754) as the base & the catches from FPV Rover V2 (https://www.thingiverse.com/thing:2952852).

The purpose was to have a sturdier, vented, top panel for my Rover v2 build. The GoPro mount was a separate item & glued on later.

An additional version has the sturdy vent holes, but no antenna hole

This was made with Tinkercad. Edit it online https://www.tinkercad.com/things/8yo1aW7YDvb

I have also included the modified inner frames with the louvers replaced with a more sturdy grid structure.

Done in Tinkercad, links to the models here:
https://www.tinkercad.com/things/3Mehf33ZH7t
https://www.tinkercad.com/things/7TFQeGDoXYN

Big Track 2 - a different profile, but the same overall height as big_track v1.1 which was the starting point. Not yet tested but should print upside down without supports. Intended for print with 95A (semi-flexible) TPU

Two other Big Track variations : nubs & ridges
Both should be printed upright from TPU. They do not have the locating pegs, just a flat bottom. I attached them to the track tops with a rubber impregnated CA glue from Bob Smith Industries (see Amazon).

This was made on Tinkercad. Edit it online https://www.tinkercad.com/things/l4Z1lU2mgoM

Category: R/C Vehicles