Descendants remix

This is a great model from Rockytfox, but I didn't fancy printing it as it was, so I used TinkerCAD and split the gold tail in half but still printed with supports. I also put a hole in the bottom so I could put a tea light inside. I then used yellow cellophane over the D so it glows with the light rather than a bare LED shining through, or using a printed D which might be a little dim.
I also added the bite back in and printed it red to simplify the printing, it doesn't look as good but prints easier.

Print Settings

Printer Brand:

FlashForge

Printer:

Rafts:

Yes

Supports:

Filament:
Sunlu Pla Red and Gold

Category: Sculptures