September 30, 2024
Description
Bambu A1 LED Bar Rear with mounts for the top of the printer.
Nozzle: 0.4
Filament: PTEG
Infill: 25%
Wall Loops: 3
Supports: Yes, Tree
The LED strip, switch, 4-Pin connector are available at 3dMachinist Etsy Store
The LED Bar is 270mm long. It has been designed to allow the LED strip to slide into the bar, with the right side of the bar adjusted for the wire connector boot to slide in.
I did not use the 3M adhesive strip to attach the strip to my light.
If you would like, you can buy me a cup of coffee.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
7
mfetting
