DJI RC231 adjustable tablet holder (up to 11")

Printer settings: 

1. material: I recomend PETG/ABS/ASA. PLA is option also but it may suffer under the sun.
2. walls: 4-4-4.
3. layer height: 0.25mm.
4. supports are not mandatory. It is adopted to non-supported print.
5. Mouse ears depending on your heatbed adhesion. 
6. TPU settings are mentioned in 'Optional" section below.

To assemble holder you will need

1. M4 15mm screw
2. M4 heatsink nut (or print already threaded part)

Optional

1. TPU soft pad to be printed and glued into "adjust nut". Print walls as 3-3-3 and 10% infill. No supports.
2. Any soft material can be used as alternate one to make grip tighter and prevent scretching the tablet.

Support creator here: 

PayPal me :)

Patreon