Houston Astros Logo Wall Art - No AMS or MMS Needed

My home office needed some sprucing up with 3D-printed Houston sports decorations. These are available in two sizes: 190mm and 264mm in diameter.

Because I do not own an AMS or MMS, this “puzzle-like” design allows you to print each piece in your choice of colors.  My K1 Max was tuned and calibrated for the PLA filament listed below.  These were designed with a .15mm tolerance, so each piece snuggly fit without issues for me.  I did use a few dabs of CA glue to secure each piece.

I drilled a tiny hole through the 3D print for a picture-hanging nail to hang these on my wall.  You could also use Command strips.

SETTINGS
Orca Slicer is my preferred slicer of choice.
Layer Height: 0.2mm
Infill Density: 10%
Infill Pattern: Cross Hatch
Wall Loops: 3
Top Layers: 5
Bottom Layers: 3
Support Needed: No

FILAMENTS USED
Blue PolySonic PLA
Orange Print Bed PLA
White Overture PLA