Lenovo Legion Go Joystick Covers

I wanted to create a print-in-place protector similar to what I've seen out there for the Steam Deck. This has very tight tolerances. Print topside down with supports for the center bit. 

Once completed, remove the supports then with a knife gently separate the hinge at the seams. Then move it open and closed a few times. 

Magnets are 4mm x 2mm. I needed to glue them in.

Printed at .2mm height with 20% infill and printed a little slower than normal for PLA.

Supports are needed for the center. (I tried I swear)

This is my first fully print-in-place model. Let me know if there is room for improvement on the joint.