Sawyer Squeeze Drip Cap

Do you hate when grungy mysterious pond water soaks your fresh undies during a backpacking trip?
Well here's a cap for the unfiltered side of your sawyer squeeze water filter. 
Print in place swivel so the cap can turn freely and is secured to the filter so you don't lose it.
You'll need about 12 inches or 32mm of 550 paracord, remove one internal core strand and tie it around the groove of the filter.

Will attach my .3MF file, but pretty standard settings;

15% infill

2 wall

No supports needed

Printed in PLA or PETG

Print Orientation standing up from seal surface

For post process; use a thin kitchen knife or card to break loose the seams around the swivel, and give it a good spin to work it in.
------------------------------------------------------------------

Included .stl/.step/.3mf files

If you're happy with the design, and had a successful print, AND you're feeling generous, you can tip me no more than a buck or two on my PayPal:

http://paypal.me/bombastic3D

Appreciate those that do! Thanks