XTool P2 Corner Square Guide

XCS Project: https://www.designfind.com/inspiration/15796

I purchased a honeycomb bed for my X2 P2, but I found it hard to lay out projects and make them square. The laser is not able to reach 0,0 of the project.

To solve this, I created a square that fits in the corner and brings (0,0) into the laser range.

To Use:

• Cut out a square on the laser
• Place the square in the corner of the laser bed
• Apply tape to X-Offset, Y-Offset
• Lable the offset of X,Y to reach (0,0) of the square
• Use plastic panel fasteners to hold the square in place