HSW mount for Bosch AL-1830-CV

Honeycomb storage wall (HSW) mount for the Bosch DIY/Gardena AL-1830-AL charger. 

When slicing from STL, put the object with the HSW holders facing top.  You will need two instances of the part.

Print settings:

• Support is only required below the end of the bars.
• Tested with PETG, but PLA should work as well. I used PETG as it could get warm in my garden shed.
• I printed with 20% Gyroid infill, but I guess 15% Grid will work also.

Assembly instructions:

• Print two parts of the mount plate
• Place them with the longer part of the screw hole to the outside of the charger (see picture below)
• Use 4 M3x20 screws to replace the original screws and attach the mount plates to the charger.

Disclaimer: This is my very first model I uploaded to Printables. I am open for any comments, suggestions, improvements for the model itself and the model description as well.