Shampoo Bottle Holder

This is a simple shampoo bottle holder for the shower. It is designed to hold your bottle upright or upside-down without tipping over as easily.

My shampoo bottles use sphere-ish caps, which makes storing them upside-down (to get that last bit of conditioner out of the bottle) incredibly frustrating. This part just helps the bottle stay where I want it without falling over. The part has multiple drain-holes to keep from retaining water and uses the no-slip feet to slightly raise it off of the shelf-floor to allow adequate air-flow and drainage.

Parts

• Adhesive-backed no-slip feet - 12.7mm x 3.5mm - x4

Assembly

• Stick the no-slip feet into the sockets on the bottom of the part

Print Settings

• Support: None
  • The rubber-feet sockets may droop a bit with PETG, but its fine, these are covered with the rubber feet anyway
• Filament: (almost) anything
  • I used PETG, but this should work fine with PLA and other filaments
• Perimeters: 3
• Infill: 20% Gyroid
  • Mostly for weighting the part down

Source CAD

I used OnShape for this design and you can find the public document here: https://cad.onshape.com/documents/0057d60a310f9d47d1d05498/w/fd362080d23c943c671fff1f/e/c831359f6a1c21b1a3a33d82?renderMode=0&uiState=66c756aa4d558b234dfba1db

Everything is variable-driven, so you can easily remix this to fit your own shower bottles. You can then right-click on the part names in the list on the left side to export them as STLs/STEP files.

Filament Used

• Overture PETG Black