Radial fan adapter for community bottle dryer

So when I printed this community bottle dryer I realized that I did not have the 40x40mm fan because I used it for a different project earlier. I looked at what fans i did have and found this radial fan from my old MK3S+ after upgrading it to MK3.9. The adapter can be secured by four 30mm M3 screws.

I made the model in around an hour so it is not totally refined. You have to use supports.

There is also a little hole below the fan, that hole is made for a cable tie that will tie the cable coming out of the fan to the model so that it doesn't just dangle around. I then soldered a USB-C female connector to the end of the cable so that i can power it off of any USB power adapter.