VanShoes

Are you tired of stinky shoes inside the Campervan? Are you tired of leaving outside and put on your weat shoes because the puddle of the night rain? You don't want insects on your shoes?
NO PROBLEM! You can install the VanShoes to your van and forgot about those problems!

Just put two modules under your van and attach easily the supports when you camping. Then you can put your shoes onto the VanShoes and enjoy the fresh air inside your van!

RECOMENDATIONS

• Print with a resistent material as it will be outside atleast the base (no sunlight exposure).
• Infill more than 30% can handle perfectly a mountain boot.
• Print the base vertically so you will not need supports.
• You can print the support flat so you will be able to avoid supports but if you print on a lateral will be more resistant.
• Base installed with 6.75mm screew with the flat head and 2mm chamfer.
• 0.2mm layer it's fine.
• 3-4 wall line count outside to inside.
• I used brim but I'm sure with a Prusa you can avoid it 😉

ATRIBUTIONS

Model made with FreeCAD

Inspired by own experience camping with van