KM4CFT CFT1 Transceiver Cover

Print this magnetic cover to protect your CFT1, and provide the perfect stand for table-top operation.  Rubber pads on four points provide stable, grippy security for your rig as you operate.

Use 2 colors of PETG to match your custom CFT1 case. 

PRINTING:

For best results, I recommend printing with 2 outer perimeters, 4 top/bottom layers, and 25% infill.  Decent bridging performance is needed for the ~25mm bridges. PETG strongly recommended for outdoor/in-vehicle temperature stability. 

Hardware needed (Amazon affiliate links):

• 10x2mm magnets: https://amzn.to/4eaHLRV
• 10mm Rubber Pads: https://amzn.to/3z4CSeq

The attached gcode is set up for two color changes and a pause for magnet insertion.  These occur about 45 minutes in and occur on consecutive layers. 

Layer 15: Color change

Layer 16: Pause to insert magnets

Layer 17: Color change 

Enjoy!