Magnepan LRS / LRS+ Stands

Using the existing mounting holes and screws, these stands will hold your Magnepan LRS or LRS+ panels vertical and raise them 2” or 3” depending on which version you choose.

I used Orcaslicer to slice the part with 10% gyroid infill (minimum), 0.24 layer height, and 3 walls. However, I added modifiers to increase the infill to 50% (rectilinear) around the screw holes to make this area stronger as shown in the picture.

There is also a version in each height with 9mm clearance holes if you decide to add generic aftermarket 8mm threaded spikes.

Bracket hole spacing on the LRS/LRS+ versions is 2.0" (50.8mm). Please verify before printing.

Printed with Eryone Black PETG.

Recommended material: PETG or PETG-CF.

*** 12-12-2024 Sweep Versions Added ***

These additional versions have a smooth sweeping transition on the front.

*** 05-25-2026 Magnepan .7 Versions Added - FOR TEST ONLY ***

These versions are to be considered TEST ONLY and will be confirmed by user who requested them. Bracket hole spacing revised to 52mm per user. Please measure and/or test with the fixture before printing.