Scorpionz... with Rotating Tail and Pincers that Nip!

Print-in-Place design of a Scorpion. The tail rotates up and over. The pincers also rotate and, when squeezed, open to grab onto things. Another fun print!

Refer to instructions for print settings to ensure it is strong enough. NO SUPPORT REQUIRED.

After printing, carefully snap/cut away the Raft so you don't damage the legs or Pincers in particular. As soon as the Raft is removed the tail should rotate up and over the Scorpionz back and Princers move and nip/grab onto things. Take care when you first rotate the pincers so they break away cleanly. Just a gentle wriggle / twist should clean it away fine.

The standard design print is approx. 17 cm in length. This could be scaled up but scaling down will not work as it will affect internal clearances and could also make the joints too weak.

There is also a 'short' version (15.7cmlong) available which has one less link in the tail. It still works fine and will enable Scorpionz to be printed on machines with smaller build plates. If rotated to 45 degrees, the model will fit on a build plate measuring 13cm x 13cm.

Note: If you like this check out all my other designs and post pictures of your prints!

'Z-REX' http://www.thingiverse.com/thing:1594269

'Ratz' http://www.thingiverse.com/thing:1532944

Sharkz http://www.thingiverse.com/thing:910216

'Crocz' http://www.thingiverse.com/thing:941177

'Woodpeckerz' http://www.thingiverse.com/thing:1155168

'Eaglez' http://www.thingiverse.com/thing:963892

'Catz' http://www.thingiverse.com/thing:988088

Tips: Tips are not expected but are appreciated as they help offset my filament costs as much as anything else. However, as I live outside the USA tips cannot be sent to me via PayPal.Me as that service is not supported in my region and this is beyond Thingverse's control. If you feel like sending a tip please use regular PayPal and send it to [email protected] and, to those who do, thanks in advance!